Category Archives: What Customers Should Know

Such a Little Part (Climate Control Resistor)

You expect your heater/air conditioner to work like it should.  You have a control for temperature and one for fan speed.  You even have a control for what vents the air comes out of.  Don't be surprised one day if your blower fan develops a mind of its own and starts going crazy.  Most of the time, you may find that it starts blowing at full speed, and nothing you do to try to control it does any good.  This is what may be happening. Your blower motor has an electronic component called a resistor.  It does what its name says; it offers resistance.  When you want the fan to run more slowly, you turn the fan speed down.  That resistor accomplishes that by turning its resistance up.  When the resistor fails, the power has nothing to slow it and the fan speeds up.  It's a small part and can fail due to age or corrosion.  It's usually not an expensive part, either, but it's often found in a location that's not that easy for the technic ... read more

That Vexing Vapor Venting (Vapor Coming out of Vents)

You may have noticed sometimes on a hot and humid day, vapor will come out of your vehicle's vents when you have the air conditioning on.  Is that something to be concerned about? Well, it depends. Sometimes that steam or vapor can be caused by water accumulating in the vent system after it has condensed.  And sometimes water can pool at the bottom of a vent.  When you turn on the blower mower, the air hits the water and may create steam or vapor that you can see in the cabin. One thing to check is if that vapor smells like anything.  If it doesn't, that's a good sign. You may be able to run the fan for a while and the issue may just go away when things dry out.  But moisture collecting in the ventilation hoses in a hot vehicle may be a breeding ground for mold, and that can have health consequences. There's another possibility. Ventilation systems often have drains to get rid of any accumulated water, and debris can sometimes clog them.  A technician can ... read more

Move it or Lose It (Dormant Vehicles)

When it comes to your vehicle, driving it too much can cause some issues.  But what about not driving a vehicle enough? That has consequences as well. Here are a few things that can happen if a vehicle isn't driven enough.  When the engine doesn't operate, the oil isn't lubricating. That means some mechanisms that need periodic lubrication aren't getting it.  And oil that sits around breaks down over time.  In fact, some experts say you should change oil more often if your vehicle sits in the driveway than if you drive it regularly.  You've heard that expression, "Take it on the highway and blow out the engine.” Well, carbon buildup used to be a problem in older vehicles.  But the real culprit these days is moisture that builds up from combustion if your vehicle never gets hot enough to burn it off. That water vapor can mix with oil and cause sludge to form. There are many vehicle systems (battery, exhaust system, engine seals, etc.) that benefit fro ... read more

Low Power Mystery (Ignition Coil Service)

It's no fun when your vehicle just doesn't run the way it used to.   You may notice (especially in cold weather) the engine won't start easily or when it does start, it doesn't run smoothly. It may not have much power at all. You also may have had to stop at the gas station more often, a sign your fuel economy isn't what it used to be.  There could be a few different things that cause those symptoms, but one culprit could be a bad ignition coil. The coil takes the voltage from your battery and multiplies it before that power is sent over to a spark plug. That allows the plug to fire off a good jolt of electricity that ignites the fuel in your cylinder and powers the engine.  There's usually one ignition coil for each cylinder (or sometimes for a pair of cylinders). If only one of them is not pushing out enough electricity, it can cause big trouble with your engine performance.  Other signs of a bad ignition coil include engine backfire, an oil leak and your Che ... read more

Power Failure (Broken Power Seat)

Know anyone who doesn't love a power seat in an SUV, a car, truck or van? They're convenient and precise in their adjustments.  But when they break, oh, what a pain.  Not only is it inconvenient, it may leave your seat position too close to the steering wheel or too far from the pedals.  This is a must-fix problem. There are many things that cause a power seat to fail: Seat controls.  These are either at the side of the seat or in the door.  Both are places that can be exposed to moisture or other contaminants.  When the controls stop working, they usually need to be replaced. Seat motor.  Electric motors are what make a power seat move, and sometimes they fail.  Sometimes they just get worked to death and die of old age.  Replacement is the most common remedy. Fuses. A power seat is, after all, powered by electricity and all vehicle power systems have fuses to protect them.  A technician can determine which fuse may have blown and rep ... read more

Out with the Old (Vehicle Parts that Wear Out)

Some drivers don't pay any attention to their vehicles until something breaks.  Others take them into their service repair facility for maintenance even before a problem develops.  Still, even if you fit into the second group, there are some parts on a vehicle that will simply wear out over time. Your vehicle has gaskets in several places.  They use a flexible material to seal the gaps between metal parts that fit together. After time, that material shrinks or gets brittle and fails.  Eventually, after time, you will have to get gaskets replaced. Same goes for belts.  Your engine has belts that help take the mechanical energy of the engine to drive other parts such as the generator and air conditioner.  Heat and age will eventually cause these belts to wear out or break, so you'll need new ones at some point. You'll also find yourself buying brake pads.  As much as you may try to go easy on them, brake pads work by wearing off a little bit of them eac ... read more

Getting from E to F (Fuel Gauge Problems)

Who thinks about their fuel gauge?  You probably don't… until it doesn't work any more.  Then you have to guess how much fuel is in your tank, and that's no way to live life on the road.  Fuel gauges, like every other part in your vehicle, can fail.  And when yours stops working, you will probably want to head over to your service facility soon, because no one relishes running out of fuel. The fuel gauge system is much more than just the gauge you can see on your instrument panel. Most systems have a float inside the fuel tank that goes up and down depending on the fuel level.  It's called the fuel sending unit, and it sends an electrical signal to the gauge (on the dash) telling it to display how much fuel is left in the tank.  So, what could go wrong?  Well, a few things.  For one thing, corrosion from bad fuel can cause it to stick and it won't move up and down any more.  So you could fill up your tank and the gauge would still rea ... read more

The Daily Grind (Grinding Noise)

If your vehicle makes a grinding sound when you turn the steering wheel, it's speaking to you.  No, really, it is.  So listen to what it's saying and you could avoid a much more costly repair down the road. A grinding sound coming from the front of your vehicle when you are turning can offer some very informative clues as to what's going on.  One cause could be that there's a problem with the mechanical linkage that enables you to turn the wheels.  Another is that the hydraulic system that makes turning the steering wheel easier may have its own problems.  Think of it.  Hydraulic power steering has many components that need to work in tandem.  The power steering fluid may be too old and contaminated.  Or its level may be low. That may be caused by a leak somewhere in the system. A technician can check things over to find out exactly what's happening. Other causes of grinding while turning can be problems with the suspension in the front.  Yo ... read more

No Strain, No Gain (The Basics of Oil Filters)

Ever wonder what one of the best things is to ever happen to your vehicle's engine?  It's the little thing that usually looks like a can, the oil filter. Just like your kitchen sink strainer filters out errant particles of food from clogging your drain, the oil filter cleans out small particles that could cause your engine harm. Your engine operates in a dirty, hot environment and gathers a lot of tiny contaminants like dirt, dust, little metal shards and unlucky bugs that get sucked in.  Get those things circulating in your engine and those little particles can cause friction, which starts wearing out those finely machined metal parts.  You know how important it is to change your oil regularly.  It's vital that you change your oil filter at the same time to keep the oil as close to brand new as possible. Most oil filters look like a metal can with some holes in the bottom.  Inside there are carefully chosen materials that can screen out the contaminants while ... read more

Slippery When Wet (Driving on Wet Leaves)

When the leaves fall, you might take a sightseeing trip to see them at peak color.  Or you may simply live in a spot where there are a lot of trees.  When those leaves get wet, you'd be surprised to learn just how slippery they can be.  We all know ice is slippery to drive on.  What causes tires to slip on ice is a thin layer of water that comes between the road and your tires.  Wet leaves can have the same effect.  The surfaces of leaves are super slick when they're dry, even worse when you add a little moisture.  There's one other thing about leaves.  They are smaller than each tire's footprint, so your tread grips the pavement with uneven traction. One study showed that your stopping distance can more than double on a surface covered with wet leaves when compared to that same road when it's dry.  Double! That can spell trouble.  So if you find yourself heading into an area with wet leaves on the road, slow down before you get into a ... read more