Scottsbluff Auto Repair

Most would agree they'd rather drive around in a clean, shiny vehicle than one coated with a layer of dirt.  When warmer weather comes around, some of us are bound and determined to wash our own vehicles.  And to protect the paint and its luster, there are a few things to keep in mind when you get out the bucket and soap. Cool body.  It's not a good idea to wash a vehicle when the body is hot.  If it's been sitting out in the sun or you've been riding around on a sunny day, make sure you cool your vehicle off by either moving it to the shade or wetting it down with cool water. The problem with washing a hot vehicle is that it's going to dry so fast, minerals in the water can form hard-to-remove spots on the paint.  And some of those can be really difficult to get out.  Best to avoid it. Slippery when wet.  Make sure you wet your vehicle down thoroughly before you get the washing mitt out.  Experts keep a couple of buckets of soapy water on hand ... read more

If every road was straight and smooth, we wouldn't have to worry much about wheel alignment. But they're not, so we do.  Hitting potholes or driving on rough pavement can knock your vehicle out of alignment and you'll notice it in one of several ways. Your steering wheel may not be centered when you're driving straight ahead, or your vehicle may pull to one side.  You may find your tires wearing on one side or they may squeal.  All are signs that could point to you needing an alignment. Your wheels should be perpendicular to the road and parallel with each other.  If not, your tires will wear out faster and your vehicle won't go straight on a level straightaway. In alignment, there are several factors that must be checked.  One is camber.  Your wheels should be straight up and down if you look at them from the front. If not, you'll wear your tires unevenly on one side. Another factor is caster, the angle of the steering pivot.  Most vehicles have what ... read more

Rust.  It's worse if you drive in places that use salt on the roads in winter, or if you spend time driving near a body of salt water.  But any vehicle has to deal with rust after years on the road.  And it's not just that rust can eat away your vehicle's body and fenders.  It can be a real problem around your suspension, drivetrain or any place where there's metal. Rust takes its time.  You don't see it until it's already done its dirty work.  It can wreak havoc with your electrical system.  Sure, vehicle manufacturers do their best to keep it to a minimum, but especially with road treatments like brine around, their task is a difficult one. The one spot everyone notices is in the paint.  You see a little bubbling under the once-smooth surface.  By the time it bubbles, it's well involved in rotting away that spot of your vehicle.  You wouldn't believe how just a little thing can start the process on its way.  A stone chips the pai ... read more

Your vehicle may be wearing boots right now and you might not even know it.  They're called ball joint boots.  They're actually protective, flexible things that protect parts of your suspension (called ball joints) from all the hazards the road can fling at them.  If one of those ball joint boots fails and you don't get it replaced, the ball joints themselves could wind up failing, a repair that can be even more expensive.  Ball joint boots not only keep things like rocks, salt, water and dirt out of your ball joints, they also help the ball joints keep their lubrication inside and working properly.  To do that, the boots have to be made of a flexible material, sometimes rubber, sometimes a synthetic.  They do take a beating, exposed to temperature extremes and debris, and eventually they can tear or crack just because of their age.  Unless someone is keeping an eye on your ball joint boots, you may never know there's a problem.  That's why when ... read more

You've probably never paid much attention to the writing on the sides of your tires, but they contain a wealth of information.  There's a long combination of letters and numbers that can tell you a whole lot about what tires your vehicle was designed to be riding on.  Let's check out this example found on an SUV: P245/70R17 108T. The first letter, P, means it's intended for passenger vehicles.  If there's no letter, it means it's a metric tire.  If there's an LT at the beginning or end that means a tire designed for light trucks. Moving on to our example, the 245 shows how wide the tire is in millimeters from sidewall to sidewall.  The number that follows in our example, 70, means the height of the tire is 70% of its width.  The letter after that in our example, R, describes the type of tire (on this vehicle, radial).  Following that is the diameter in inches, in our SUV example, 17 inches.  How much load the tires' sidewalls are designed to take ... read more

We all have joints in our own skeletal system, but did you know your vehicle has some joints of its own? One of the most important is called a ball joint. One of the interesting things is that it's somewhat similar to the ball and socket joints we have in our hips and shoulders.  A ball joint allows two parts it joins together to move in more than one direction at the same time. Think about your wheels.  They have to move up and down when there are bumps in the road but in sideways directions when you are making a turn. As you can see, the ball joints are important for your steering and handling to work correctly. Since ball joints do so much, they can wear out and become loose.  When the ball wears down or the socket gets worn, there can be too much play in them.  It can get so bad that the ball can come out of the socket and your wheel can fall off, a dangerous situation.  Ball joints can also seize up.  Some of them are sealed and never require maintena ... read more

So you thought you only had two brake lights.  Look again and you'll see one in the center at a higher level than the two on either side of the vehicle.  They're sometimes in the inside of the vehicle behind the back window, or they could be in the deck lid, on the roof or on the spare wheel carrier, But why is that third brake on your vehicle? Experts say it helps prevent rear end collisions. Tests done by installing the third brake light in taxis and fleet vehicles showed fewer rear end crashes in the ones that had the extra light. The third brake light was mandated in new passenger cars in 1986 in the US and Canada.  The requirement was added to new light trucks and vans in 1994. Sometimes it's difficult to know if your third brake light is even working.  Many vehicles have bulb warning systems that alert you to non-functional bulbs, but not all do. Your vehicle service facility will often check to see if all your turn signals, taillights and headlights are worki ... read more

It's happened to all of us.  We're driving down a highway at night and over a crest appears a car with its high beams blazing.  You are momentarily blinded, hoping the other driver will switch them to their low beam setting and restore your vision. Not only do we not appreciate being blinded, face it; we don’t want to be that other driver, either.  You know, the one who forgets to turn down their high beams. Why do we want high beams in the first place? They can improve safety when used correctly, giving drivers more reaction time since they can see farther down the road.  But research has found many drivers either don't use them or, when they do, they frequently forget to switch to low beams.  Enter the automatic high-beam dimmer. The quest for the perfect one began back in the 1950s, General Motors invented something it called the "Autronic Eye." It was a phototube which sat on the dashboard and turned down your beams when it saw other headlights.  ... read more

We usually take our vehicle's easy steering for granted until something goes wrong.  Power steering is what makes it almost effortless to turn the steering wheel, aiming your vehicle in the direction you want to go. Without the assistance of power from the engine, steering would be a laborious process, so you want to make sure the system is working well. Power steering systems are usually one of two types, hydraulic and electric.  The hydraulic type uses a pump that is driven by either a belt or an electric motor.  This system uses hydraulic fluid to create pressure that gives your steering the power assist.  Since that pump is always working, time and distance traveled eventually take their toll, and these systems need to be periodically inspected.  Also, while that hydraulic fluid can last for years, it should be replaced periodically as it degrades over time. Your vehicle's owner's manual contains the manufacturer's recommendations. A technician can check fo ... read more

Automotive design has come a long way since the days of the Model T, especially when it comes to safety technology.  You can thank computers for a lot of the latest innovations.  Here are a few that have been making their mark in recent years. Adaptive cruise control.  This is cruise control with a brain.  Not only will adaptive cruise control keep your vehicle going at a steady speed, it will also slow it down and even stop it if the vehicle ahead of you slows down and stops.  Automatic emergency braking.  We've all been distracted while driving, and you've probably been in a situation where the driver ahead of you has suddenly stopped.  Or maybe your attention wandered for a minute and you looked up to see your vehicle closing in fast on the car ahead of you.  (After all, there are a lot more distractions in your vehicle these days.)  New systems that use cameras, lasers and other types of sensors will warn you to start braking.  If y ... read more